McKinley Dollhouse Build Blog (Roof Editing)

May 26 2008
Posted by Minis On The Edge
Roof Editing

I started with foam core just to see if this design would work and if it would look really nice. I ended up cutting the roof height (on the raised roof side) down to 8" high. This is what it looked like in the beginning:

It took a while (3.5 hrs. ) to get the angles right because I found out that this house needed a little more support now that I was bashing it away from how it should have been done.

This is after I added the wood roof & attic parts. It was level on one side and not the other and I went around and around with the leveler I did finally get it right . After I got it to the point where I was satisfied , I added sandpaper and painted it black to give the roof floor an "Asphalt" look. I then added the Chimney stack :

I wanted to add roof trim to give the roof more detail. At first I started off by using the kits trim:

I ended up using some iron railing for the widows walk instead. 

I aged it with a sea foam green paint:

Thank you for stopping by to read this blog!