The roof has been attached without any issues. These wires were fed to the outside walls. Because the wires were too short to reach the base, they had to be lengthened and soldered to the bottom base. Then they were soldered to the tape wire:
I added tape wire to the bottom base (1st floor). I will solder the wires from the lights & outlets to the tape wire.
I soldered all of wires to the strip of tape wire.
This is the attic painted with only one shade of paint so far. Torches has been added:
fireplace is lit too
walls painted
Thank You For Viewing My Blog! If you have questions, please post it in the comment section. Others may have the same question. Click the Link to See Day 10 of The Pierce Building Blog
Awesome, you did the same thing that I am doing, adding flooring, papering, etc. as I construct.
ReplyDeleteIt is so much easier that way then trying to do it after it is all assembled.
It looks awesome what you've done so far by the way.
My question is about the second set of double doors at the side entrance. The bay portion for the OUTSIDE has those three little panels.
My question is does the lower panel (the one with the cut out at the top go where the little corner piece of the roof attaches?
I think I assembled it correctly, but the written instructions don't show a detailed plan for this.
I hope my educated guess is correct.
Thanks for any hints and tricks.
It's such an awesome dollhouse isn't it?!
I've enjoyed putting it together emencely.
Have a wonderful day, and keep up the good work.